03Checking Voltage Drops Tech Tip130006272016
03Checking Voltage Drops Tech Tip130006272016 TECH Tips CHECKING VOLTAGE DROPS Is it really that important? Sometimes what is thought to be a battery, alternator or starter problem is actually charging system problems due to high or unwanted resistance. There's only one method of determining if there is an adequate delivery path for optimum starting, charging, battery performance and life. The electrical problems related to excessive voltage drops are more common than you may realize. Think of your starting and charging cables as a two-way street. The battery needs to deliver its available power to the starter through the cables and connections for cranking the engine. In turn, the alternator needs to replenish the battery and provide the power for the vehicle loads through the charging cables and connections. If the street is too narrow to carry the current, it shows up in measurable âvoltage dropâ or loss. This is often manifested in short battery life, frequent jump-starts or perceived alternator and starter problems. Itâs not uncommon for an alternator or starter to be replaced because itâs believed to be faulty or run its normal life cycle... only to later discover that the root cause of the problem doesnât reside with the alternator or starter. High or unwanted resistance is one contributing factor that leads to cranking and charging system problems. High resistance is often caused by one of these four main issues: ⢠⢠Loose connections ⢠⢠Corrosion in the cables and wiring ⢠⢠Improperly sized wiring or cables ⢠⢠Improperly crimped connectors While a technician may regularly do a visual inspection of cables and connections it doesnât really show what is going on inside the cables or inside the connections. This is why the concept of voltage drop testing is the only sure method of determining if there is an adequate current delivery path for optimum starting, charging, battery performance and life. âA voltage drop test is a good âbest practiceâ during your scheduled preventative maintenance or before replacing the battery, starter or alternator,â explains Clint Stohler, Director, Technical Service and Training. âOne volt drop generally equals a loss of 30 engine cranking rpms.â Scan with your smartphone for video instructions on how to properly test your battery, alternator and starter! Conducting a Voltage Drop Test Equipment needed: ⢠⢠Voltmeter ⢠⢠Carbon pile load tester A voltage drop test will assess voltage losses at the battery, the alternator and the starter. Part 1: Battery 1. With the voltmeter connected to battery, and key and engine off, record a "base" voltage reading. (Your battery should have a minimum of 12.4 volts.) If it is less than 12.4 volts, charge the battery and repeat the test. 2. If the voltage is greater than 12.6 volts (AGM batteries 12.8 volts), surface charge must be removed. 3. To remove surface charge, turn on the headlights and blower motor (high speed) for one minute. Then turn off the devices and wait two minutes for the voltage to stabilize. 4. Once you have a reading that is between 12.4 and 12.6 volts you will then start the engine and bring it to normal operating temperature. 5. With the engine at 1,500 to 2,000 rpm, turn on all electrical loads (lights, blower fan, A/C, etc.). The charging voltage should be at least 0.5 volt above base voltage reading. If not, excessive resistance could be present. Continued on back... CATALOG NUMBER 03 www.midwestwheel.com NLINE www.midwestwheel.com Order NLINE ⢠Made with FlippingBook RkJQdWJsaXNoZXIy MTEyNjY3NA==